Semibatch emulsion polymerization of butyl acrylate. II. Effects of emulsifier distribution

The effects of emulsifier distribution ratio between the initial charge and the feed on particle formation and kinetics of butyl acrylate emulsion polymerization, using sodium lauryl sulfate as emulsifier and potassium persulfate as initiator, were investigated. The number of particles increased with initial emulsifier concentration in the reactor charge. It was shown that traditional ranking, in terms of number of particles produced, of semibatch emulsion polymerization with monomer emulsion feed is not always justified and a semibatch emulsion polymerization can produce far more particles than a conventional batch emulsion polymerization. The number of polymer particles was found to be practically independent of the emulsifier distribution ratio between the charge and the feed for a high overall emulsifier concentration, while for a low overall emulsifier concentration, the number of particles increased with initial loading of the emulsifier. The polydispersity index (PDI) of the final latexes showed a minimum with emulsifier distribution. A bimodal particle size distribution, and a latex with a large PDI, was obtained when there was no emulsifier in the charge. As the initial emulsifier charge increased, a unimodal PSD with a smaller PDI was obtained. With higher proportions of emulsifier in the initial charge, the PDI rose again due to particle nucleation at monomer-starved conditions, and a skewed unimodal PSD was obtained. © 2000 John Wiley & Sons, Inc. J Appl Polym Sci 79: 582–597, 2001