Micromagnetic Simulation of L10-FePt-Based Transition Jitter of Heat-Assisted Magnetic Recording at Ultrahigh Areal Density

The areal density of hard disk drives increases every year. Increasing the areal density has limitations. Therefore, heat-assisted magnetic recording (HAMR) technology has been the candidate for increasing the areal density. At ultrahigh areal density, the main problem of the magnetic recording process is noise. Transition jitter is noise that affects the read-back signal. Hence, the performance of the magnetic recording process depends on the transition jitter. In this paper, the transition jitter of L10-FePt-based HAMR technology was simulated at the ultrahigh areal density. The micromagnetic simulation was used in the magnetic recording process. The average grain size was 5.1 nm, and the standard deviation was 0.08 nm. The recording simulation format was five tracks in a medium. It was found that a bit length of 9 nm with a track width of 16.5 nm at the areal density of 4.1 Tb/in2 had the lowest transition jitter average of 1.547 nm. In addition, the transition jitter average decreased when increasing the areal density from 4.1 to 8.9 Tb/in2. It was found that the lowest transition jitter average was 1.270 nm at an 8 nm track width and a 9 nm bit length, which achieved an ultrahigh areal density of 8.9 Tb/in2.