2010Unpublished venueRequires access

Boosted HCCI for high power without engine knock and with ultra-low NOx emissions - Using conventional gasoline

JE Dec, Yi Yang

Open publisher page 18 citations

Abstract

The potential of boosted HCCI for achieving high loads has been investigated for intake pressures (P in) from 100 kPa (naturally aspirated) to 325 kPa absolute. Experiments were conducted in a single-cylinder HCCI research engine (0.98 liters) equipped with a compression-ratio 14 piston at 1200 rpm. The intake charge was fully premixed well upstream of the intake, and the fuel was a research-grade (R+M)/2 = 87-octane gasoline with a composition typical of commercial gasolines. Beginning with P in = 100 kPa, the intake pressure was systematically increased in steps of 20 - 40 kPa, and for each P in, the fueling was incrementally increased up to the knock/stability limit, beyond which slight changes in combustion conditions can lead to strong knocking or misfire. A combination of reduced intake temperature and cooled EGR was used to compensate for the pressure-induced enhancement of autoignition and to provide sufficient combustion-phasing retard to control knock. The maximum attainable load increased progressively with boost from a gross indicated mean effective pressure (IMEP g) of about 5 bar for naturally aspirated conditions up to 16.34 bar for P in = 325 kPa. For this high-load point, combustion and indicated thermal efficiencies were 99% and 47%, respectively, and NOx emissions were < 0.1 g/kg-fuel. Maximum pressure-rise rates were kept sufficiently low to prevent knock, and the COV of the IMEP g was < 1.5%. Central to achieving these results was the ability to retard combustion phasing (CA50) as late as 19°after TDC with good stability under boosted conditions. Detailed examination of the heat release rates shows that this substantial CA50 retard was possible because intake boosting significantly enhances the early autoignition reactions, keeping the charge temperature rising toward the hot-ignition point despite the high rate of expansion at these late crank angles. Overall, the investigation showed that well-controlled boosted HCCI has a strong potential for achieving power levels close to those of turbo-charged diesel engines. Copyright © 2010 SAE International.

About this research paper

What this paper is about

The potential of boosted HCCI for achieving high loads has been investigated for intake pressures (P in) from 100 kPa (naturally aspirated) to 325 kPa absolute. Experiments were conducted in a single-cylinder HCCI research engine (0.98 liters) equipped with a compression-ratio 14 piston at 1200 rpm. The intake charge was fully premixed well upstream of the intake, and the fuel was a research-grade (R+M)/2 = 87-octane gasoline with a composition typical of commercial gasolines. Beginning with P in = 100 kPa, the intake pressure was systematically increased in steps of 20 - 40 kPa, and for each P in, the fueling was incrementally increased up to the knock/stability limit, beyond which slight changes in combustion conditions can lead to strong knocking or misfire. A combination of reduced intake temperature and cooled EGR was used to compensate for the pressure-induced enhancement of autoignition and to provide sufficient combustion-phasing retard to control knock. The maximum attainable load increased progressively with boost from a gross indicated mean effective pressure (IMEP g) of about 5 bar for naturally aspirated conditions up to 16.34 bar for P in = 325 kPa. For this high-load point, combustion and indicated thermal efficiencies were 99% and 47%, respectively, and NOx emissions were < 0.1 g/kg-fuel. Maximum pressure-rise rates were kept sufficiently low to prevent knock, and the COV of the IMEP g was < 1.5%. Central to achieving these results was the ability to retard combustion phasing (CA50) as late as 19°after TDC with good stability under boosted conditions. Detailed examination of the heat release rates shows that this substantial CA50 retard was possible because intake boosting significantly enhances the early autoignition reactions, keeping the charge temperature rising toward the hot-ignition point despite the high rate of expansion at these late crank angles. Overall, the investigation showed that well-controlled boosted HCCI has a strong potential for achieving power levels close to those of turbo-charged diesel engines. Copyright © 2010 SAE International.

Why it matters

OpenAlex reports 18 citations for this work. Citation counts describe recorded attention and do not establish research quality.

Key contribution

A contribution statement is not available in the OpenAlex record.

Method / approach

Method details are not available in the OpenAlex metadata.

Main findings

Findings are not separately available in the OpenAlex metadata.

Limitations

Limitations are not available in the OpenAlex metadata.

Applications

Application details are not available in the OpenAlex metadata.

Available abstract

The potential of boosted HCCI for achieving high loads has been investigated for intake pressures (P in) from 100 kPa (naturally aspirated) to 325 kPa absolute. Experiments were conducted in a single-cylinder HCCI research engine (0.98 liters) equipped with a compression-ratio 14 piston at 1200 rpm. The intake charge was fully premixed well upstream of the intake, and the fuel was a research-grade (R+M)/2 = 87-octane gasoline with a composition typical of commercial gasolines. Beginning with P in = 100 kPa, the intake pressure was systematically increased in steps of 20 - 40 kPa, and for each P in, the fueling was incrementally increased up to the knock/stability limit, beyond which slight changes in combustion conditions can lead to strong knocking or misfire. A combination of reduced intake temperature and cooled EGR was used to compensate for the pressure-induced enhancement of autoignition and to provide sufficient combustion-phasing retard to control knock. The maximum attainable load increased progressively with boost from a gross indicated mean effective pressure (IMEP g) of about 5 bar for naturally aspirated conditions up to 16.34 bar for P in = 325 kPa. For this high-load point, combustion and indicated thermal efficiencies were 99% and 47%, respectively, and NOx emissions were < 0.1 g/kg-fuel. Maximum pressure-rise rates were kept sufficiently low to prevent knock, and the COV of the IMEP g was < 1.5%. Central to achieving these results was the ability to retard combustion phasing (CA50) as late as 19°after TDC with good stability under boosted conditions. Detailed examination of the heat release rates shows that this substantial CA50 retard was possible because intake boosting significantly enhances the early autoignition reactions, keeping the charge temperature rising toward the hot-ignition point despite the high rate of expansion at these late crank angles. Overall, the investigation showed that well-controlled boosted HCCI has a strong potential for achieving power levels close to those of turbo-charged diesel engines. Copyright © 2010 SAE International.

Key concepts: Mean effective pressure, NOx, Gasoline, Homogeneous charge compression ignition, Combustion, Automotive engineering, Naturally aspirated engine, Bar (unit)

Related papers

Back to paper searchBrowse research topicsOriginal source
Boosted HCCI for high power without engine knock and with ultra-low NOx emissions - Using conventional gasoline — Research Paper | ScholarLens