Lead metal biosorption and isotherms studies by metal‐resistant Bacillus strain MRS‐2 bacterium

Abstract In this study, lead (Pb) biosorption studies in aqueous solution were performed with metal‐resistant Bacillus strain MRS‐2 (ATCC 55674) bacterium which was previously isolated from wastewater plant. It showed minimum inhibition concentration of 300 ppm Pb on the nutrient agar plates. Pb biosorption using MRS‐2 bacteria was investigated under different parameters such as pH, temperature, biomass dosage, initial Pb concentration, contact time, and type of biomass by batch experiments. Pb concentration was analyzed through Inductively coupled plasma‐optical emission spectrometry. The rate of biosorption (Q) and Pb biosorption capacity (qe) were calculated for above mentioned parameters. It was observed that Pb precipitates by itself from the solution at pH 2 and 8 or above without bacteria and precipitation did not increase even in the presence of bacteria. The results showed that the highest biosorption rate and biosorption capacity (mg/g) were observed at pH 7, 25°C, 2‐h contact time with live bacteria. The highest biosorption rate was observed at 1.5 g/L biomass dose and 5 ppm initial Pb concentration, whereas the highest Pb biosorption capacity was observed at 0.25 g/L biomass dose and 12.5 ppm initial Pb concentration. It was observed that Pb biosorption by live bacteria occurred through adsorption on cell surface. In this study, the biosorption isotherm analysis favored the Langmuir isotherm model indicating monolayer biosorption. This Bacillus strain showed higher Pb biosorption capacity than most of the previously reported Bacillus strains. In conclusion, this study indicates that the Bacillus MRS‐2 strain can be used to remove Pb from industrial wastewaters in an ecofriendly approach.