Enhancing aerodynamic performances of a high-turning compressor cascade via boundary layer suction

Experimental investigation was carried out to study the effect of suction positions and suction flow rates on the aerodynamic performance of a compressor cascade with a large camber angle. The ink-trace flow visualization was conducted and the flow fields of the cascade were also measured. Three types of boundary layer suction configurations are compared,i.e. the suction surface suction,the endwall suction and the compound suction. Experimental results show that the large amount of suction flow rate gains more losses reduction than the small amount for a certain proper suction configuration,but the speed of loss decline slows down as the suction flow rate goes on increasing. Boundary layer suction on the suction surface obviously enhances the ability of the boundary layer around the midspan to withstand the negative pressure gradient of the flow passage. The range of the suction surface corner is also decreased. If the suction slot locates in the corner separation region where severe separation has happened,the flow separation will be terminated at the slot and redevelop downstream. And boundary layer suction on the endwall mainly influences the endwall corner region in remarkably delaying,lessening and reorganizing the corner separation. While the whole flow field is remarkably improved at both midspan and the corner region in the compound suction schemes. At higher suction flow rates,the aerodynamic performance of the compressor cascade is better than that with boundary layer suction simply on the suction surface or on the endwall. When the suction flow rate is 1.5% of the inlet mass flow,the compound suction scheme achieves a maximum loss reduction of 17% compared with the cascade without boundary layer suction.