Effects of Final Cooling Temperature on Microstructure Transformation and Properties of Q550 Low Carbon Bainite Steel

The mechanical properties of low carbon bainite steel are closely related to the microstructure and proportion after phase transformation. The microstructure of the deformed austenite of low carbon bainite steel after isothermal transformation and continuous cooling transformation was studied by thermal simulation test. The metallographic structure was observed by optical microscopy (OM) and scanning electron microscopy (SEM). The metallographic and microhardness were used to judge the microstructure type, and the CCT (continuous cooling transformation) curve and TTT (time-temperature-transformation) curve of the test steel were drawn. It was found that at 700-430 °C isothermal, undergo a variety of medium-temperature microstructure transformations appeared for the test steels, such as ferrite, pearlite, granular bainite and lath bainite. The cooling rate and final cooling temperature have great influence on the type and performance of the final microstructure. The final cooling temperature was controlled at about 515°C. The mixed microstructures of granular bainite (GB) and fine martensite-austenite (M-A) island, a small amount of acicular ferrite and lath bainite were obtained. The yield and tensile strengths of this type of microstructure reached 639 MPa and 750 MPa respectively, the shrinkage rate reached 17%, and the better low-temperature impact performance was realized.