A Novel Low Output Offset Voltage Charge Amplifier for Piezoelectric Sensors

The charge amplifier is an important building block in various electronic circuits. In this paper a new charge amplifier for piezoelectric sensors is introduced. The advantages of the new proposed charge amplifier becomes obvious in the quasi-static applications. In some quasi-static applications the traditional charge amplifiers uses an extremely large feedback resistor (in the range of GQ) whereas the proposed charge amplifier no longer requires such extremely large resistors. Moreover the proposed circuit reduces the output offset voltage significantly in comparison with conventional charge amplifier. The proposed circuit can be also implemented by using general purpose JFET operational amplifiers instead of using electrometer operational amplifiers therefore the cost of implementation will be reduced significantly in comparison with conventional charge amplifier. The proposed charge amplifier was assembled by using general purpose JFET Op-Amp to capture and amplify the output voltage of the piezoelectric vibration sensor Minisense100. In this experiment the low-cutoff frequency and the gain of the proposed charge amplifier were set equal to 0.2Hz and 20.5 dB respectively. The output offset voltage of the circuit was measured equal to 210 μV .The measurement of very small vibration (±0.015g) showed a relative error equal to 2.1% with respect to the value which is obtained by using vibration meter as reference.