Blocker-tolerant Receiver Design Suitable for Software-defined and Cognitive Radio Applications

The ever growing demand for higher data rates and the heavy usage of wireless communication devices have created frequency congestion on certain bands of the radio spectrum. The push has been towards new standards that can quench this thirst for data capacity and more space on the spectrum. This has led to added complexity and cost for radio platforms. In particular, the increase in the number of antennas, switch banks and pre-select filters have made it challenging to implement these platforms cost-effectively. Therefore, concepts such as software-defined radio(SDR) and cognitive radio(CR) have been proposed to tackle this problem. These concepts, allow the use of a single wideband receiver which can handle multiple radio standards spread across the entire spectrum of interest. The introduction of a common flexible hardware platform eliminates the use of multiple off-chip RF pre-filters and thus lowers cost, reduces complexity and form factor. While attractive, these future radio receivers pose a number of unique challenges to the designer. This thesis focuses on frequency translation (FT) techniques and addresses two key SDR/CR challenges: the robustness to out-of-band interference (OBI) or block-ers and the compatibility with CMOS scaling and system-on-chip (SoC) integration. The thesis studies the principles and the performance limitations of existing FT tech-niques and proposes new circuit-and-system techniques to improve the performance of wideband receivers suitable for SDR and CR applications. First, the performance of the frequency translational resistive feedback receiver frontend is studied and analyzed. Instead of using a conventional LNA, the job of the LNA is shared along the receiver chain through the utilization of frequency translation techniques. This approach significantly relaxes the trade-off between noise, out-of-band linearity and wideband operation. Though frequency translation is at the core of the receiver functionality, it is accomplished using time-varying, strongly nonlinear passive mixer circuits. So the operation and noise performance cannot be understood using standard LTI circuit analysis techniques. To this end, an in-depth LTV analysis is presented which accurately captures the gain, input matching and the noise performance of the receiver. Next, a wideband blocker tolerant receiver with an RF frequency range of 0.1 GHz to 2.2 GHz is proposed. By using frequency-translational resistive shunt-feedback, the receiver achieves frequency selective input match across its entire range of operation. Four techniques for improving blocker tolerance of the receiver have been utilized: 1) voltage amplification only after baseband filtering 2) blocker rejection at the antenna interface using an N-path filter 3) blocker current cancellation in the baseband 4) frequency translational noise cancellation which uses an auxiliary path to cancel the noise of the main path. By introducing an auxiliary path, the value of the RF transconductor in the main path is halved which in turn…