Studies of vortex flaps for different sweepback angle delta wings
Kenichi Rinoie
Abstract
Kenichi Rinoie
Abstract
Abstract Low speed windtunnel measurements were made on a 50° delta wing with leading edge vortex flaps. Improvements in the lift/drag ratio were obtained by deflecting the leading edge vortex flap. Comparisons were made between the previously measured 60° and 70° delta wing results and the present 50° wing results. Improvements in the lift/drag ratio of the 50° delta wing were attained over a wider lift coefficient range than for the 70° delta wing. The highest lift/drag ratio for the 50° delta wing is achieved when the flow attaches to the flap surface without any large area of separation. Estimations of the aerodynamic forces were also made using a quasi-vortex lattice method coupled with the leading edge suction analogy for the 50°, 60° and 70° delta wings. The results obtained from this analysis agree qualitatively with the experimental results.
OpenAlex reports 5 citations for this work. Citation counts describe recorded attention and do not establish research quality.
A contribution statement is not available in the OpenAlex record.
Method details are not available in the OpenAlex metadata.
Findings are not separately available in the OpenAlex metadata.
Limitations are not available in the OpenAlex metadata.
Application details are not available in the OpenAlex metadata.
Abstract Low speed windtunnel measurements were made on a 50° delta wing with leading edge vortex flaps. Improvements in the lift/drag ratio were obtained by deflecting the leading edge vortex flap. Comparisons were made between the previously measured 60° and 70° delta wing results and the present 50° wing results. Improvements in the lift/drag ratio of the 50° delta wing were attained over a wider lift coefficient range than for the 70° delta wing. The highest lift/drag ratio for the 50° delta wing is achieved when the flow attaches to the flap surface without any large area of separation. Estimations of the aerodynamic forces were also made using a quasi-vortex lattice method coupled with the leading edge suction analogy for the 50°, 60° and 70° delta wings. The results obtained from this analysis agree qualitatively with the experimental results.
Key concepts: Delta wing, Vortex lift, Wingtip vortices, Wing, Vortex, Lift (data mining), Lift-to-drag ratio, Drag