WEAR RATES OF HIGHLY CROSS LINKED POLYETHYLENE IN TOTAL HIP ARTHROPLASTY USING 36MM HEADS – A MINIMUM 2 YEAR FOLLOW-UP STUDY.

The aim was to assess the wear rate of highly Cross Linked (X3) polyethylene with the use of 36mm femoral heads in total hip arthroplasty (THA). We have previously reported our early results and raised some concern regarding the potential excessive femoral head penetration rates. These results give the 2 year wear rates following this initial bedding-in phase. There were 100 consecutive patients who had a THA with the same femoral and acetabular components using a 36mm femoral head and X3 polyethylene that were assessed prospectively. Validated computer software (Polyware) was used to assess linear and 3 dimensional wear using standardised x-rays. Examinations were performed at 2,12,18 and 24 months. There were 40 hips that had completed the 2 year x-ray examination (average 2.4 years). The mean 2-dimensional linear wear rate was 0.17 mm/yr and the mean volumetric wear rate was 113.73 mm3/yr. Steady state wear was achieved after the 2 month and before the 1 year examination. The steady state wear rate was 0.001mm/yr. There was no difference in wear rate with the different sized cups used and wear rate was independent of liner thickness. The early high wear rates reported have now settled into a more expected pattern of steady state wear similar to other results presented in literature with the use of smaller femoral heads. Using a 36 mm femoral head has not adversely increased the wear rates compared to smaller head sizes when used in conjunction with X3 polyethylene in the short term for THA. These results suggest that the wear rate of X3 is not compromised even with thinner liners and raise the possibility of safely using even larger head sizes with this polyethylene.