Experimental Investigations on the Ground Effect Characteristics of the U-shaped and V-shaped Wing Designs for the Aero-Train
Tomoyuki ISHIZUKA, Yasuaki Kohama, Takuma Kato, Shuya YOSHIOKA
Abstract
Open-access reader
Tomoyuki ISHIZUKA, Yasuaki Kohama, Takuma Kato, Shuya YOSHIOKA
Abstract
Open-access reader
This paper describes the investigations on the aerodynamic characteristics of a U-shaped and V-shaped wing in ground effect. The lift, drag, side force, and rolling moment were measured in a low turbulance wind tunnel, using a 6-component balance. The flow over the upper surface was visualized by the tuft method. The results obtained were as follows : The U-shaped and V-shaped wing had an almost equivalent lift-to-drag ratio compared to a planar wing. This was due to the dihedral angle of U-shaped and V-shaped wing, resulting in a decrease of the induced drag. While separation only occurred on the V-shaped wing at an attack angle of 6 degree, a higher lift-to-drag ratio of the U-shaped wing was obtaind at attack angle of 4 and 6 degree. With both wings, an almost equal restoring force and an even higher restoring moment were obtained than with a conventional box shaped wing. Thus, the U-shaped and V-shaped wing offer a more suitable wing configuration for the Aero-Train than a conventional wing does.
OpenAlex reports 7 citations for this work. Citation counts describe recorded attention and do not establish research quality.
A contribution statement is not available in the OpenAlex record.
Method details are not available in the OpenAlex metadata.
Findings are not separately available in the OpenAlex metadata.
Limitations are not available in the OpenAlex metadata.
Application details are not available in the OpenAlex metadata.
This paper describes the investigations on the aerodynamic characteristics of a U-shaped and V-shaped wing in ground effect. The lift, drag, side force, and rolling moment were measured in a low turbulance wind tunnel, using a 6-component balance. The flow over the upper surface was visualized by the tuft method. The results obtained were as follows : The U-shaped and V-shaped wing had an almost equivalent lift-to-drag ratio compared to a planar wing. This was due to the dihedral angle of U-shaped and V-shaped wing, resulting in a decrease of the induced drag. While separation only occurred on the V-shaped wing at an attack angle of 6 degree, a higher lift-to-drag ratio of the U-shaped wing was obtaind at attack angle of 4 and 6 degree. With both wings, an almost equal restoring force and an even higher restoring moment were obtained than with a conventional box shaped wing. Thus, the U-shaped and V-shaped wing offer a more suitable wing configuration for the Aero-Train than a conventional wing does.
Key concepts: Wing, Drag, Wingtip vortices, Washout, Wing twist, Lift-to-drag ratio, Wing loading, Lift-induced drag