Study of the Influence of Contact Geometry and Contact Pressure on Sliding Distance to Galling in the Slider-on-Flat-Surface Wear Tester

One of the major causes of tool failure in sheet metal forming is wear in the form of galling. Galling is gradual buildup of adhered sheet material on the tool and leads to unacceptable scratches on the sheet surface and to components that fail to meet tolerances. Because it is difficult to reproduce operational and interactional conditions in laboratory test equipments it is hard to test, model, and predict galling initiation. Here the authors examine how changes from elliptical to line contact geometry influenced galling initiation under dry sliding by using a slider-on-flat surface (SOFS) wear tester. A micro clean tool steel was tested against ferritic low-strength and martensitic high-strength steel sheets. The sliding distance to galling initiation was extracted from friction data and verified by scanning electron microscopy (SEM) observations. The presence of adhesive wear on worn tools after completed tests was used as a criterion. Experimental results showed that the elliptical contact causes galling quicker than the line contact. Applicability of experimental results depends on the relevance of test conditions, so contact pressures calculated for the described tests were compared to calculated contact pressures in a semi-industrial U-bending test and to literature data relevant to industrial applications. Good agreement between values observed for SOFS and for most selected industrial applications was found, which assume that contact pressures typical for most common industrial applications can be successfully simulated by selection of tool geometry and normal load in the SOFS tester.