Adsorption of Anionic–Cationic Surfactant Mixtures on Metal oxide Surfaces

Abstract This research evaluates the adsorption of anionic and cationic surfactant mixtures on charged metal oxide surfaces (i.e., alumina and silica). For an anionic‐rich surfactant mixture below the CMC, the adsorption of anionic surfactant was found to substantially increase with the addition of low mole fractions of cationic surfactant. Two anionic surfactants (sodium dodecyl sulfate and sodium dihexyl sulfosuccinate) and two cationic surfactants (dodecyl pyridinium chloride and benzethonium chloride) were studied to evaluate the effect of surfactant tail branching. While cationic surfactants were observed to co‐adsorb with anionic surfactants onto positively charged surfaces, the plateau level of anionic surfactant adsorption (i.e., at or above the CMC) did not change significantly for anionic–cationic surfactant mixtures. At the same time, the adsorption of anionic surfactants onto alumina was dramatically reduced when present in cationic‐rich micelles and the adsorption of cationic surfactants on silica was substantially reduced in the presence of anionic‐rich micelles. This demonstrates that mixed micelle formation can effectively reduce the activity of the highly adsorbing surfactant and thus inhibit the adsorption of the surfactant, especially when the highly adsorbing surfactant is present at a low mole fraction in the mixed surfactant system. Thus surfactant adsorption can be either enhanced or inhibited using mixed anionic–cationic surfactant systems by varying the concentration and composition.