Influence of cooling rate on microstructure and properties of high strength steel weld metal

Microstructures, and hence mechanical properties, of high strength steel weld metals are affected by cooling rate. Weld metal microstructures for a nominal composition of Fe–0·05C–0·3Si–2Mn–3Ni–0·5Cr–0·6Mo (wt-%) were therefore characterised for a range of cooling rates using high resolution scanning electron microscopy, and transformation behaviour, assessed from cooling curves, is presented as a continuous cooling transformation diagram. As deposited last bead microstructure changes gradually from lower bainite and martensite interspersed with coalesced bainite, via a mixture of relatively fine upper and lower bainite, to coarse upper bainite as cooling rate decreases. The microstructure of reheated beads follows the as deposited structure closely and becomes coarse with slower cooling. Mechanical properties correlate with observed microstructure and transformation behaviour. Results suggest high strength and good toughness for cooling rates between 800 and 500°C of about 3–13 s. A fine microstructure will then form with varying proportions of martensite, lower bainite, coalesced bainite and fine upper bainite.