Contact angle measurements and interpretation: wetting behavior and solid surface tensions for poly(alkyl methacrylate) polymers

Low-rate dynamic contact angles of a large number of liquids were measured on a poly(ethyl methacrylate) (PEMA) polymer using an automated axisymmetric drop shape analysis profile (ADSA-P). The results suggested that not all experimental contact angles can be used for the interpretation in terms of solid surface tensions: eight liquids yielded non-constant contact angles and/or dissolved the polymer on contact. From the experimental contact angles of the remaining four liquids, we found that the liquid-vapor surface tension times the cosine of the contact angle changes smoothly with the liquid-vapor surface tension, i.e. γlv cos ζ depends only on γlv for a given solid surface (or solid surface tension). This contact angle pattern is again in harmony with those from other methacrylate polymer surfaces of different compositions and side-chains. The solid-vapor surface tension of PEMA calculated from the equation-of-state approach for solid-liquid interfacial tensions was found to be 33.6 ± 0.5 mJ/m2 from the experimental contact angles of the four liquids. The experimental results also suggested that surface tension component approaches do not reflect physical reality. In particular, experimental contact angles of polar and nonpolar liquids on polar methacrylate polymers were employed to determine solid surface tension and solid surface tension components. Contrary to the results obtained from the equation-of-state approach, we obtained inconsistent values from the Lifshitz-van der Waals/acid-base (van Oss and Good) approach using the same sets of experimental contact angles.