The three‐dimension finite element analysis of stress in posterior tooth residual root restored with postcore crown

OBJECTIVE: Teeth that have been endodontically treated and restored with postcore crown may experience fracture sometimes. Some researchers have analyzed the stress of the anterior teeth after postcore crown restoration, but the stress of the posterior teeth after such restoration has not been reported. We used three-dimension finite element methods to analyze the stress magnitude and distribution of remaining dentin in posterior tooth residual root restored with postcore crown. The binding material, loading direction, number, length and material of posts were studied. METHODS: The models of residual root of maxillary first molar restored with postcore crown were created by CT scanning, mimics software and abaqus software. Different number, length and material of posts were used in the modeling. The posts were cemented with zinc-phosphate cement or composited resin. A load of 240 N was applied to the occlusal surface in four directions and tensile, shear, and von Mises stresses were calculated. RESULT: (i) The maximum stress on remaining dentin changed irregularly as the number and length of posts changed. (ii) The maximum stress on remaining dentin decreased slightly as elastic modulus of the material of posts increased. (iii) The maximum stress on bonding layer and remaining dentin was lower when bonded with resin luting agent than with zinc-phosphate cement. (iv) The maximum stress on remaining dentin increased markedly as loading angle increased. CONCLUSION: The number, length, material of posts, bonding material and loading angle all have influence on the magnitude and distribution of stress. The influence of loading angle is most apparent.