Integrated display of multi-sensor geophysical and electromagnetic flight data

Low-altitude wind shear has been identified by several aviation interests as a significant hazard to the safety of flying. The hazard may be greatest when the wind shear is due to an unpredicted and short-lived microburst occurring in the immediate flight path of an aircraft during takeoff or landing. Researchers from the NASA Langley Research Center have investigated wind shear by developing a suite of remote sensing instruments and then using these instruments in an airborne wind shear detection flight program. Among these instruments were a Doppler radar, a lidar, and an infrared sensor; these were supported by in situ measurements of aircraft and environmental parameters and by ground-based Doppler radars. The basic problem addressed was the airborne detection and measurement of meteorologically-induced wind shear sufficiently ahead of the aircraft to allow avoidance. If the remote measurements of the shear and its associated radar reflectivity did not exceed set limits, the airplane then continued through the wind shear so that in situ measurements could be made for comparison. Initial detection and vectoring to the wind shear was normally given from a ground-based Doppler weather radar and most of the wind shear events were due to microbursts, both wet and dry. This paper considers the problems of sampling the wind shear event, time and space registration among the various sensors, coordination of the various sensors' beams and sampling volumes, and also various techniques for portraying the data, both for research and for presentation. Examples are given based on data from the 1991 and 1992 NASA/FAA wind shear flights, and the results and conclusions are generalized to other flight experiments involving multi-sensor electromagnetic data sets.